Philips 200 - Manual (Page 7)

Setting up the
Setting up the ONIS 200 1
Installing the ONIS 200
Safety and Security
Your DECT compliant ONIS 200 telephone draws on the latest technology to make it both easier and
more comfortable to use.
The ONIS 200 consists of 2 parts: the BASE STATION (immobile), and one or more cordless
HANDSETS allowing you to call without the need to remain in close proximity to the base station.
For maximum communication quality, do not place the BASE STATION close to electric appliances
(refrigerators, televisions, microwaves, other cordless sets, radios, computers, etc.), in front of or on large
metal or reinforced concrete surfaces, or too close to metal doorframes.
As with other radio connections, obstacles between the BASE STATION and the HANDSET may reduce
range.
The BASE STATION should not be kept in a damp place and should be at least 1.50m away from any
source of water. Do not allow the HANDSET to come into contact with water (swimming pools,
baths, etc.).The charging contacts should be kept away from conductive objects (metal objects, keys,
jewellery, etc.).
ENVIRONMENTAL PROTECTION:Your HANDSET has been designed in compliance with the Philips
EcoDesign program, which takes environmental factors into consideration throughout the product’s life
cycle.
WARNING: A telephone which does not require a mains supply should also be available, in addition to
your ONIS 200, in order to provide constant access to emergency services.
The ONIS 200 and ONIS Vox 200 are compliant with the operator’s analogue interface.The ONIS 200
and ONIS Vox 200 can only be connected to the English telephone network.
The geographical area in which the equipment may be used is shown on the label under the base unit.
The CE mark on your telephone means that it is compliant with the European directive on technical regulations for user safety,
electro-magnetic interference and radio tests 99/05/CEE.
Electric connection: 230V mains supply, single phase AC, with the exception of IT-type equipment compliant with standard
EN 60-950. (NOTE: Excessive mains voltage limits are defined according to criteria laid out in the same standard).
Operating temperature is between 5° C and 45° C.The mains power pack has a 230V supply sectioning feature to protect the user.
As a preventive measure, this should be close to the equipment and easily accessible.
Telephone connection: network voltage is classed as telephone network voltage in compliance with EN 60-950.
NOTE:You are about to use an approved DECT-type telephone that allows private intercommunication between cordless phones and a
cordless PABX or a domestic terminal.The use of this equipment is subject to conditions specified by the decree of January 13, 1995,
published in the “Journal Officiel” on January 26, 1995, defining general licensing conditions in compliance with Article L.89 of the
“Code des Postes et Télécommunications”. In addition to the approval of the equipment, the following conditions of use must be
respected, particularly in view of the use of radio frequencies:
1. DECT equipment is not guaranteed against jamming by other authorized use of radio frequencies;
2. DECT equipment may be used to connect fixed points, only if these connections are not permanent and the equivalent isotropic
radiated power at the antenna is less than 50 mW;
3. DECT equipment (cordless PABX type with more than two network access lines) must be installed by an agent approved by the
telecommunications ministry. Such installations are complex, as defined in Article R. 20-22 of the “Code des P. et T.”;
4.Telepoint network access conditions for DECT equipment must be subject to an agreement signed with the authorised telepoint
network operator concerned.
mettre en service 24/04/01 14:22 Page 1