Philips 200 - Manual (Page 46)

Settings
Settings 40
The code is shown on the label
underneath the base station
(RC...).
After a few moments, the screen
displays “Recording ...”, followed
by “Set !”. If this is not the case,
begin the procedure again.
Adding another ONIS 200 handset to the base
station
You can use up to 8 handsets on the ONIS 200 base station.
A handset must be registered with the base station before it can be used with that base station.
To register a handset, use the following procedure:
Unplug and plug back the power adapter in
the base station. After a few seconds, the base
station will emit a double “tone”.
Under the “Handset Settings” in the “Settings”
menu, scroll to “Register handset” and select
OK|.
Enter the 4-digit registration code on the base
station and select OK|. 3
2
1
Scroll to “Regist. Mode” under the
“Base settings” heading in the “Settings” menu
and select OK|.
Enter the registration code that comes with
the peripheral (e.g. 0000) and select OK|.
For the next 5 minutes, you can use the base
station to register your peripheral
(see peripheral instructions). 3
2
1
DECT peripheral without keypad
Some DECT peripherals, such as repeaters, do not have a keypad. A special menu-operated procedure is
used to register such peripherals with the base station without the need to disconnect the base station.
L NOTE:
If the additional handset is not an ONIS 200 model but is GAP-compliant, refer to the relevant instructions.
Registration code:
_
CORRECT OK
Recording...
Registration code
_
CORRECT OK
Reglages 19/04/01 14:44 Page 40