Set up the rip function – Paradyne 1740 SHDSL User Manual

Page 40

1740 SHDSL 2/4-Wire Router User’s Guide

Delete:

STEP 1: Select the entry you wish to delete from the List of Static Routes

STEP 2: Change the parameters

STEP 3: Click on the Delete button

7.2

Set Up the RIP function

To enable the RIP, complete the following steps:

STEP 1: Click Routing Setup from the Basic menu bar

STEP 2: Select On in the Rip Status field.

STEP 3: Select a RIP Version (Version 1 or Version 2) from the Version field.

STEP 4: Click Apply to submit the settings.

To configure the advance functions of the RIP, click on the RIP tab on the main screen, and configure the
requested parameters.

Mode:

Select Enabled

Version:

RIP version 2 or version 1

Authentication:

none: no authentication code is required.

PlainText: an authentication code is required. You should also fill in
the Authentication Code field to assign a password.

MD5: an authentication code is required. You should also fill in the
Authentication Code field to assign a password.

40 July 2004 1740-A2-GB20-00