Router mode: service for five static ip addresses – Paradyne 1740 SHDSL User Manual

Page 18

1740 SHDSL 2/4-Wire Router User’s Guide

3.2.2

Router Mode: Service for Five Static IP Addresses

To set up the service for five static IP addresses, you need to set up the VC in RFC 1483 Routed mode.

STEP 1: Click WAN Setup on the Basic menu bar.

STEP 2: Enter values for: VPI, VCI, Encapsulation (LLC or VC MUX), Enable NAPT.

VPI

Enter a value for the vitual path identifier

VCI

Enter a value for the virtual channel identifier

LLCEncapsulation:

With LLC encapsulation, a link control header is added to the
Ethernet packet that identifies the protocol type (Ethernet). This
allows multiple protocols to be transmitted over the ATM Virtual
Circuit.

VC Multiplexing:

With VC Multiplexing, no link control header is needed as the
ATM Virtual Circuit is assumed to be carrying a single protocol.

Enable NAPT

Selecting Enabling NAPT will enable Network Port Address
Translation on the WAN interface.

STEP 3: Click on the RFC 1483 Routed option.

18 July 2004 1740-A2-GB20-00