Printek FormsMaster 8000 - Manual (Page 35)

Epson FX Emulation
29
Escape Sequence: ESC 6
Hexadecimal: 1B 36
Disable Printing of High Symbols ESC 7
Disables printing of character values 128 through 159 decimal. These characters will be treated as
control codes. Overrides the “Characters” value in the interface setup menu.
Escape Sequence: ESC 7
Hexadecimal: 1B 37
Printing of Low Symbols ESC I n
Enables printing of character values 0 through 31 decimal if they are not used as control codes for n=1,
or disables printing for n=0. Overrides the “Characters” value in the interface setup menu.
Example: The following escape sequence will disable printing of character values 0 through 31
decimal.
Escape Sequence: ESC I 0
Hexadecimal: 1B 49 30
Line Pitch
Select 8 LPI ESC 0
Sets the line spacing to 1/8 of an inch per line (8 lpi). Overrides the “Lines/Inch” value in the forms
menu.
Escape Sequence: ESC 0
Hexadecimal: 1B 30
Set Line Spacing to 7/72” ESC 1
Sets the line spacing to 7/72 of an inch per line. Since the distance between print head wires is 1/72 of
an inch, this is equivalent to setting seven wire spacing. This is not particularly useful for text, but
may be useful for graphics if 7-bit graphics data is being sent. Overrides the “Lines/Inch” value in the
forms menu.
Escape Sequence: ESC 1
Hexadecimal: 1B 31
Select 6 LPI ESC 2
Sets the line spacing to 1/6 of an inch per line (6 lpi). This is the normal text line spacing. Overrides
the “Lines/Inch” value in the forms menu.
Escape Sequence: ESC 2
Hexadecimal: 1B 32