Printek FormsMaster 8000 - Manual (Page 22)

ANSI X3.64 Emulation
16
Emulations
Select Software Interface n ESC ESC n
Selects the software interface n according to the table below.
n Software Interface
0 Test (reserved for factory use)
1 ANSI X3.64 Emulation
2 Epson FX Emulation
3 Bar Code Mode (optional)
4 IBM Proprinter Emulation
5 DEC LA120 Emulation
6 TTY Emulation
7 Printek Emulation
? Previously Selected Emulation
@ Default Emulation
Overrides the “Emulation” value in the interface setup menu.
A numeric value for n may be specified in two different ways, with equivalent results: a single byte
with a value of 00 to 07 hex, or a single printable ASCII character “0” to “7” (30 to 37 hex).
If more than one emulation has been selected, ESC ESC ? will return to the previously selected
emulation. This is particularly useful when the previous emulation is unknown. Please beware that the
memory (stack) is only one level deep.
ESC ESC @ will return to the default emulation, as specified by the “Emulation” value in the interface
setup menu.
This chapter describes ANSI X3.64 emulation. If a different interface is selected, the control codes
and escape sequences described in this chapter will no longer be applicable.
Example: The following escape sequences will select Printek emulation, load form one, and then
return to the previous emulation.
Escape Sequence: ESC ESC 7 ESC L 1 ESC ESC ?
Hexadecimal: 1B 1B 07 1B 4C 01 1B 1B 3F