Redialing, Automatic redialing, Manual redialing – Panasonic DX-2000 User Manual
Page 92: Sending document with sender selection, Sending documents via lan
90
Redialing
Automatic Redialing
(see Note 1)
Manual Redialing
You can also redial the last dialed number manually by pressing
key.
If a communication error is detected with Information Code 710, 714,
715, 716, 717 or 725, the machine will redial the number up to 5
times at 3 minutes interval. However, if other errors are detected, the
machine will redial only one time. During that time, a message will
appear as shown to the right.
A file number is shown in the upper right hand corner of the display.
1. While the unit is displaying "WAIT TO DIAL", you can press
to start redialing immediately.
1
Set document(s) face down.
Make sure that the MEMORY lamp is on.
2
3
The document is stored into memory with a file number.
Then dials the last dialed number.
WAIT TO DIAL NO.001
(Email address)
REDIAL
REDIAL
ENTER STATION(S)
THEN PRESS START 00%
PAUSE
REDIAL
START
* STORE * NO.001
PAGES=001 01%
*CONNECTING* NO.002
Sending Documents via LAN
Note: