Philips DVD740VR/001 - Manual (Page 12)

12
English
Setting Up your DVD/VCR
Connecting to Optional
Equipment (for DVD features)
● A digital component with a built-in MPEG 2 or
Dolby Digital TM decoder allows you to enjoy
the surround sound while producing the effect
of being in a movie theater or a concert hall.
● The player outputs the surround sound signals
from the DIGITAL OUT COAXIAL or OPTI-
CAL connector.
If your receiver has a MPEG 2 or Dolby
Digital™ decoder,
1 Connect the COAXIAL or OPTICAL DIGI-
TAL AUDIO OUT of the DVD/VCR to the
COAXIAL or OPTICAL DIGITAL AUDIO IN
on your receiver.
Note:
– If the audio format of the digital output
does not match the capabilities of your
receiver, the receiver will produce a strong,
distorted sound or no sound at all.
– MP3 Audio is not available on the Digital
Output.
– You will still need the video cable or RF
coaxial cable for VCR features.
Inserting batteries into the
Remote Control
1 Open the battery cover.
2
Insert batteries (AA size) with the correct
polarity as indicated by the + and - symbols
inside the battery compartment.
3 Close the cover.
CAUTION!
– Remove batteries if they are exhausted
or not to be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed off properly
and kept away from children.
Using the Remote Control
● Direct the remote control at the remote sen-
sor of the DVD/VCR.
● Do not drop the remote control.
● Do not leave the remote control near
extremely hot or humid place.
● Do not spill water or put anything wet on the
remote control.
COAXIAL
S-VIDEO
OUT
DIGITAL
AUDIO OUT
ANALOG
AUDIO OUT
L
R
AERIAL
RF-OUT
VCR DVD/VCR
OPTICAL
DVD OUTPUT ONLY
AV2 (DECODER) AV1 (TV)
AUDIO RECEIVER
COAXIAL DIGITAL
AUDIO IN
OPTICAL DIGITAL
AUDIO IN
External Input Mode (for VCR
features)
To receive the signal from an external input
(decoder, video camera, another VCR etc.),
connect to the AV2 (DECODER) socket, and
enter “002” with numerical key pads button
to appear “AV2” on the TV screen.
If you use the AV1 (TV) socket, enter “001”
with numerical key pads button to appear
“AV1” on the TV screen.
If you use the front AUDIO/VIDEO input
jacks, enter “003” with numerical key pads
button to appear “AV3” on the TV screen.