Windows me – Paradyne 6382 User Manual
Page 22
2. Hardware Installation and PC Setup
2-6
April
2005
6382-A2-GB20-00
4. If Internet Protocol (TCP/IP) does not appear as an installed component, click
on Install.
5. In the Select Network Component Type dialog box, select Protocol, and then
click on Add.
6. Select Internet Protocol (TCP/IP) in the Network Protocols list, and then click
on OK.
You may be prompted to install files from your Windows 2000 installation CD
or other media. Follow the instructions to install the files.
7. If prompted, click on OK to restart your computer with the new settings.
8. After restarting your PC, double-click on the Network and Dial-up Connections
icon in the Control Panel.
9. In Network and Dial-up Connections window, right-click on the Local Area
Connection icon, and then select Properties.
10. In the Local Area Connection Properties dialog box, select Internet Protocol
(TCP/IP), and then click on Properties.
11. In the Internet Protocol (TCP/IP) Properties dialog box, click in the radio button
labeled “Use the following IP address” and type 192.168.1.x (where x is any
number between 2 and 254) in the IP Address field. Type 255.255.255.0 in the
Subnet Mask field.
12. Click on OK twice to confirm and save your changes, and then close the
Control Panel.
Windows ME
To configure the IP address under Windows ME:
Procedure
1. In the Windows task bar, click on the Start button, point to Settings, and then
click on Control Panel.
2. Double-click on the Network and Dial-up Connections icon.
3. In the Network and Dial-up Connections window, right-click on the Network
icon, and then select Properties.
The Network Properties dialog box is displayed with a list of currently installed
network components. If the list includes Internet Protocol (TCP/IP), the
protocol has already been enabled, in which case you can skip to
4. If Internet Protocol (TCP/IP) does not appear as an installed component, click
on Add.
5. In the Select Network Component Type dialog box, select Protocol, and then
click on Add.
6. Select Microsoft in the Manufacturers box.