Philips FW M143 - Manual (Page 19)

English
19
Clock/Timer
➜ The clock digits for the minutes flash.
4 Press TITILE-/+
¡1 / 2™ (н/л on the
remote)to set the minutes.
5 Press CLOCK/TIMER to confirm the time
➜ The timer is now set and actiated.
Activating and deactivating
TIMER
● In standby or during playback, press
TIMER ON/OFF once.
➜ Display shows if activated, and disappears if
deactivated.
Activating and deactivating
SLEEP
The sleep timer enables the system to switch off
by itself after a set period of time
● Press SLEEP on the remote
control repeatly to select desired
time before system shuts off.
➜ Display shows SLEEP and
series of time options for
selection:
120, 90, 60, 45,30,
15, OFF.
● To deactivate, press SLEEP on the remote
control once or more until ‘
OFF’ is shown, or
press STANDBY-ON y (POWER y on the
remote).
Setting the clock
1 In any mode, press CLOCK/TIMER twice.
➜ The clock digits for the hours flash.
2 Press TITILE-/+
¡1 / 2™ (н/л on the
remote) to set the hours.
3 Press CLOCK/TIMER again.
➜ The clock digits for the minutes flash.
4 Press TITILE-/+
¡1 / 2™ (н/л on the
remote)to set the minutes.
5 Press CLOCK/TIMER to confirm the time.
Note:
– If the clock has not been set, 0:00 will be
displayed.
Setting the timer
● The system can be used as an alarm clock. CD
or TUNER can be set to switch on at a preset
time. The clock time needs to be set first before
the timer can be used.
● If no button is pressed within 7 seconds during
timer setup, the system will exit timer setting
mode automatically.
1 In active mode, press and hold CLOCK/
TIMER for more than 2 seconds.
2 Press TITILE-/+
¡1 / 2™ (н/л on the
remote) to set the hours.
3 Press CLOCK/TIMER again.
pg001-pg023_FWM143_37_Eng 1/28/08, 14:31 19