Philips FW M143 - Manual (Page 13)

English
13
Basic Functions
IMPORTANT:
Before you operate the system, complete
the preparation procedures.
Switching the system on
● Press STANDBY-ON y (POWER y on the
remote).
➜ The system will switch to the last selected
source.
Switching the system to Eco Power
Standby mode
● Press STANDBY-ON y (POWER y on the
remote) in the active mode .
➜ The system enters Eco power standby (the
ECO POWER LED is on) or normal standby
with clock display.
➜ The volume level (up to a maximum volume
level of 15), interactive sound settings, last
selected source and tuner presets will be
retained in the player's memory.
● If the system is in normal standby with clock
display, press and hold STANDBY-ON y
(POWER y on the remote) for 3 seconds or
more to switch to Eco power standby or vice
versa.
Power-saving automatic standby
The power-saving feature automatically switches
to standby 30 minutes after a tape or CD
playback has ended and no control is operated.
Adjusting volume and sound
1 Press VOLUME
3/4 to
increase or decrease
volume.
➜ Display shows the
volume level
UoL and a
number from 0-40.
2 Press DBB to switch bass
enhancement on or off.
➜ Display shows: DBB if
the DBB is activated.
3 Press DSC on the remote to repeatedly to
select the desired sound effect:CLASSIC,JAZZ,
POP or ROCK.
4 Press MUTE on the remote control to stop
sound play-back instantly.
➜ Playback will continue without sound and the
display shows MUTE.
● To start sound playback you can:
– press MUTE again;
– adjust the volume controls.
pg001-pg023_FWM143_37_Eng 1/28/08, 14:31 13