Installing the mgc manager, Installing the mgc manager -2 – Polycom DOC2231A User Manual
Page 34
MGC+50/MGC+100 Getting Started Guide
3-2
Installing the MGC Manager
To configure the MGC+ unit to your environment, setup conferences and
control the MGC+ unit you must install the MGC Manager software on a PC.
A single MGC Manager-enabled PC can manage multiple MCUs.
During the installation, default Reservation templates are installed.The MGC
unit is shipped with a Default IVR Service and Default Entry Queue Service.
For information about restoring these services when upgrading MCU
software, refer to the MGC Administrator’s Guide, Chapter 5.
To install the MGC Manager software:
1.
Insert the software CD into the CD drive.
2.
On the Start menu, click Run.
The Run dialog box opens.
3.
Type D:\SETUP (where D is the name of the CD drive), and then click
OK.
The installation wizard starts and the Software License Agreement
window opens.
4.
Click Yes to accept to the terms of the agreement or No to exit the
installation.
If you clicked Yes, the Welcome window opens.
5.
Click Next.
Installing the
MGC Manager
Initial IP
Configuration
Connecting
to an MCU
Configuring the
Network Services
Defining an MCU
Starting the MGC
Manager