Polycom DOC2231A - Manual (Page 27)

MGC+50/MGC+100 Getting Started Guide
2-15
3. Save the changes in the LAN.cfg file.
4. Use the Microsoft Unplug or Eject Hardware procedure prior to
removing the Flash disk.
5. Remove the Compact Flash disk from the reader.
6. Insert the Compact Flash disk into the Compact Flash slot of the MGC+
Control Module.
7. Press the Reset button on the MGC+ unit.
The Options menu appears.
8. Press 1, to Change the MGC+ IP Settings.
The Flash Memory LED must be active and flash.
Table 2-1: IP Configuration Options
Option Description
IP Address The system displays the currently defined IP address.
Enter the IP address allocated to the MCU by the
network administrator.
Subnet Mask Enter the Subnet Mask of the MCU.
Default Gateway Enter the IP Address of the default gateway/router.
Make sure no blank spaces occur at the end of each line.
Failure to stop the hardware properly can result in a corrupt Compact Flash disk.
When the disk fails, a replacement is required.
If no monitor is connected, the automatic default time-out (15 seconds) selects
option 1.