Pride Mobility SC3450 - Manual (Page 19)

19 Revo
TILLER CONSOLE
The tiller console houses all controls needed to drive your Revo, including the speed adjustment dial, key switch, throttle
control levers, battery condition meter, running lights switch, and horn buttons. See figure 5.
WARNING! Do not expose the tiller console to moisture. In the event that the tiller console
does become exposed to moisture, do not attempt to operate your scooter until the tiller
console has dried thoroughly.
V . Y O U R R E V O
Key Switch
n Fully insert the key into the key switch to power up (turn on) your Revo.
n Remove the key from the key switch to power down (turn off) your Revo.
Throttle Control Levers
These levers allow you to control the forward speed and the reverse speed of your scooter up to the maximum
speed you preset with the speed adjustment dial.
n Place your right hand on the right handgrip and your left hand on the left handgrip.
n Use your right thumb to push the right side of the lever to disengage your Revo’s brakes and move forward.
n Release the lever and allow your Revo to come to a complete stop before pushing the other side of the lever
to move in reverse.
n When the throttle is completely released, it automatically returns to the center “stop” position and engages your
Revo’s brakes.
Running Lights Switch
This button controls your Revo’s front and rear running lights.
n Toggle the switch forward to turn on the running lights.
n Toggle the switch back to turn off the running lights.
Horn Button
The key must be fully inserted into the key switch for the horn to be operational.
n This button activates a warning horn.
n Do not hesitate to use the warning horn when doing so may prevent accident or injury.
Figure 5. Tiller Console
BATTERY CONDITION METER
HORN BUTTON
SPEED ADJUSTMENT DIAL
THROTTLE CONTROL LEVER
(REVERSE)
HORN BUTTON
THROTTLE CONTROL LEVER
(FORWARD)
RUNNING LIGHTS SWITCH
KEY SWITCH
KEY
HAND GRIP