beautypg.com

Troubleshooting – Philips FW D5 User Manual

Page 42

background image

3139 115 20032

42

English

TROUBLESHOOTING

CD Player Operation

"

NO DISC" is displayed.

• The disc is inserted upside down.
™ Place disc with printed side up.
• Moisture condensation at the lens.
™ Wait until lens has adjusted to normal

room temperature.

• There is no disc in the CD tray.
™ Insert a disc.
• The disc is dirty, badly scratched or

warped.

™ Clean or replace the disc.
• The disc lens is dirty or dusty.
™ See section under Maintenance (page

41).

"

DISC NOT FINALIZED" is

displayed.
• The CD-RW or CD-R disc is not properly

recorded for use with a standard CD
player.

™ Read the instruction booklet of your CD-

Rewritable or CD-Recorder on how to
finalise a recording.

• The CD is badly scratched or dirty.
™ Replace or clean CD.

Radio Reception

Poor radio reception.
• The signal is too weak.
™ Adjust the antenna.
™ Connect an external antenna for better

reception.

• The TV or VCR is too close to the stereo

system.

™ Separate the stereo system from the TV

or VCR.

NO RDS TEXT” is displayed.

• RDS text message is not available.
™ Select another RDS station.

General

System does not react when any
button is pressed.
• Electrostatic discharge.
™ Press STANDBY ON to switch the

system off. Remove the AC power plug
from the wall outlet, then reconnect the
power plug and switch on the system
again.

No or poor sound.
• Volume is not turned up.
™ Adjust VOLUME.
• The headphones are connected.
™ Disconnect the headphones.

• Speakers are not connected or are

connected wrongly.

™ Check that the speakers are connected

correctly.

™ Make sure the stripped speaker wire is

clamped.

Reversed left and right sound.
• Speakers are connected wrongly.
™ Check the speaker connections and

location.

Lack of bass sound or apparently
imprecise physical location of musical
instruments.
• Speakers are connected wrongly.
™ Check the speaker connection for

proper phasing, coloured/black wires to
coloured/black terminals.

Remote control has no effect on the
system.
• Wrong source is selected.
™ Select the source (CD, TUNER, etc.)

before pressing the function button
(Й, н, л, etc.).

• The distance to the system is too large.
™ Reduce the distance.
• Batteries are inserted incorrectly.
™ Insert the batteries with their polarities

(+/– signs) as indicated.

• Batteries are exhausted.
™ Replace the batteries.

Timer is not working.
• Clock is not set.
™ Set the clock.
• Timer is not switched on.
™ Press TIMER to switch on the timer.

Clock setting is erased.
• There was a power failure.
™ Reset the clock.

System displays features
automatically; buttons flash
continuously.
• Demonstration mode is switched on.
™ Press and hold Ç (on the system) for

five seconds to switch off the
demonstration.

There is a howling sound at the
external source.
• You hear feedback when you are

listening in AUX mode

™ Press AUX to select CDR mode.

All lighted buttons are not lit.
• Display is switch on in DIM 3 mode.
™ Press DIM until DIM OFF display mode

is shown.

1pg 01-42/D5/22-Eng new

9/14/00, 8:37 AM

42