Philips FW D5 - Manual (Page 38)

3139 115 20032
38
English
CLOCK TIMER
View Clock
You can view the clock (if it is set) if the
system is in Standby mode or when any
sound source is selected (CD, TUNER, etc.).
The clock will be displayed for about seven
seconds.
• Press CLOCK/TIMER briefly.
™ "PM 10:38 or 22:38" (the
current time) will be displayed
depending on whether you have
selected 12- or 24-hour mode.
™ "--:--" will be displayed if the
clock is not set.
Note:
– When the system goes into low power
standby mode, the clock setting will not
be displayed.
Clock Setting
The clock can be set in either 12- or 24-
hour mode, e.g. "
AM 12:00" or
" 00:00". Before setting the clock, you
must be in the View Clock mode.
1 Press CLOCK/TIMER to select clock
mode.
2 Press PROG (on the system only) to
select 12- and 24- hour mode.
™ If 12-hour mode is selected,
" AM 12:00" starts flashing.
™ If 24-hour mode is selected, "00:00"
starts flashing.
3 Set the hour with à or á on the
system.
4 Set the minute with í or ë on the
system.
5 Press CLOCK/TIMER again to store the
setting.
™ The clock starts.
• To exit without storing the setting, press
Ç on the system.
Notes:
– During clock setting, if no button is
pressed within 90 seconds, the system
will exit clock setting mode
automatically.
– When a power interruption occurs, the
clock setting is erased.
– To set the time with RDS clock, see
"Receiving RDS Radio Station" under
TUNER section.
Timer Setting
• The system can switch on to CD or
TUNER mode automatically at a preset
time. It can serve as an alarm to wake
you up.
• Before setting the timer, make sure the
clock is set correctly.
• The timer will always be switched on
once it is set.
• The volume of the timer will
increase from the minimum level
until the volume level before the set
is switched to standby mode.
1 Press and hold CLOCK/TIMER for more
than 2 seconds to select timer mode.
™ "AM 12:00" or "00:00" or the last
timer setting starts flashing
depending on whether you have
selected 12- or 24-hour mode.
™ The TIMER starts flashing.
™ The selected source is lit while other
available sources are flashing.
2 Press CD or TUNER to select the
desired source.
• Before selecting CD, make sure a CD is
loaded in the CD tray.
3 Press à or á on the system to set
the hour for the timer to start.
4 Press í or ë on the system to set
the minute for the timer to start.
RETU RN PERSONAL
V EC DS C
D B B
STANDBY ON
DVD MINI HIFI SYSTEM
DIM PROG
POWER SAVE
IR SENSOR
RDS / CD TEXT
NEWS / T.A.
CLOCK/ TIMER
VOLUME
AXIS OK DVD
MENU
SOUND JOG DVD JOG
P3 P6 P1 P2 P5 P4
CHAP. CHAP. SLEEP DIM TIMER LW FM A M W
TUNER DVD CD AUX
A - B
PB C
BAND VCD • CD CD 1 • 2 • 3 CDR
LEFT CENTER RIGHT
SURR SURR
STOP•CLEAR SEARCH•TUNING PLAY PAUSE PREV NEXT SIDE PRESET ▲ ▲
S C A N
CHANNEL
DVD
SURROUND CONTROL
5.1CH / STEREO / SURR / 3D
FTS TITLE
1pg 01-42/D5/22-Eng new 9/14/00, 8:37 AM 38