beautypg.com

Error messages, Understanding auto ta and eq error, Messages – Pioneer Super Tuner III D AVH-P4950DVD User Manual

Page 72: Understanding auto ta and eq error messages, Additional information

background image

Error messages

When you contact your dealer or your nearest Pioneer Service Center, be sure to record the error
message.

Message

Cause

Action (See)

ERROR-02

Dirty disc

Clean disc.

Scratched disc

Replace disc.

ERROR-05

Electrical or mechanical

Press

RESET.

DIFFERENT REGION DISC (RE-
GION ERR)

The disc does not have the same re-
gion number as this unit

Replace the DVD video with one bearing the
correct region number.

NON PLAYABLE DISC (NON-
PLAY)

This type of disc cannot be played
by this unit

Replace the disc with one this unit can play.

The disc is loaded upside down

Check that the disc is loaded correctly.

THERMAL PROTECTION IN
MOTION (TEMP)

The temperature of this unit is out-
side the normal operating range

Wait until the unit

’s temperature returns to

within normal operating limits.

PROTECT

All the files on the inserted disc are
secured by digital rights manage-
ment (DRM)

Replace disc.

TRK SKIPPED

The inserted disc contains WMA
files that are protected by digital
rights management (DRM)

Replace disc.

Understanding auto TA and EQ error messages

When correct measurement of car interior acoustic characteristics is not possible using the auto
TA and EQ, an error message may appear on the display. If an error message appears, refer to the
table below to see what the problem is and the suggested method of correcting the problem. After
checking, try again.

Message

Cause

Action

Error check MIC

Microphone is not connected.

Plug the supplied microphone securely into
the jack.

Error check front SP, Error
check FL SP, Error check FR SP,
Error check center SP, Error
check RL SP, Error check RR SP,
Error check subwoofer

The microphone cannot pick up the
measuring tone of a speaker.

! Confirm that the speakers are connected
correctly.

! Correct the input level setting of the power
amp connected to the speakers.

! Set the microphone correctly.

Error check noise

The surrounding noise level is too
high.

! Stop your car in a place that is as quiet as
possible, and switch off the engine, air condi-
tioner or heater.

! Set the microphone correctly.

Additional Information

En

72

Appendix