Pioneer Super Tuner III D AVH-P4950DVD - Manual (Page 64)

FRONT (front speakers)
—CENTER (center
speaker)
—REAR (rear speakers)—
SUB WOOFER (subwoofer)
4 Touch c or d to select cross-over fre-
quency.
Each time you touch c or d selects cut-off fre-
quencies in the following order:
63
—80—100—125—160—200 (Hz)
Note
Selecting a cross-over frequency is to set a cross-
over frequency of the subwoofer
’s L.P.F. (low-pass
filter) and that of the SMALL speaker H.P.F. (high-
pass filter). The cross-over frequency setting has
no effect if the subwoofer is set to
OFF and other
speakers are set to LARGE or OFF.
Adjusting the speaker output
levels
Speaker level can be adjusted finely by listen-
ing to an audio output. First, use test tone to
adjust the approximate speaker level, and then
use this function to adjust finely.
1 Touch NEXT on the DSP function menu.
2 Touch SP LEVEL.
3 Touch a or b to select the speaker to
be adjusted.
Each time you touch a or b selects the speak-
er in the following order:
FRONT-L (front speaker left)
—CENTER (center
speaker)
—FRONT-R (front speaker right)—
REAR-R (rear speaker right)
—REAR-L (rear
speaker left)
—SUB WOOFER (subwoofer)
# You cannot select speakers whose size is set
at
OFF.
4 Touch c or d to adjust the speaker out-
put level.
Each time you touch c or d increases or de-
creases the speaker output level.
+10 to
–10 is
displayed as the level is increased or de-
creased.
Notes
! You can also display the speaker setting menu
by pressing BOOST button.
! To adjust the speaker output levels in this
mode is the same as making the speaker out-
put levels at
TEST TONE. Both provide the
same results.
Adjusting the speaker output
levels using a test tone
This function allows you to easily get the over-
all balance right among the speakers.
1 Touch NEXT on the DSP function menu.
2 Touch TEST TONE.
3 Touch START to start the test tone out-
put.
The test tone is outputted. It rotates from
speaker to speaker in the following sequence
at intervals of about two seconds. The current
settings for the speaker over which you hear
the test tone are shown in the display.
FRONT-L (front speaker left)
—CENTER (center
speaker)
—FRONT-R (front speaker right)—
REAR-R (rear speaker right)
—REAR-L (rear
speaker left)
—SUB WOOFER (subwoofer)
Check each speaker output level. If no adjust-
ments are needed, perform step 5 to stop the
test tone.
# The settings do not appear for speakers
whose size is set
OFF.
Available accessories
En
64
Section
04