Pioneer Super Tuner III D AVH-P4950DVD - Manual (Page 18)

! When the ignition switch is turned OFF
after the LCD panel has been closed, turn-
ing the ignition switch ON again (or turning
it to ACC) will not open the LCD panel. In
this case, press
OPEN/CLOSE to open the
LCD panel.
! When closing the LCD panel, check to
make sure that it has closed completely. If
the LCD panel has stopped halfway, leaving
it like this could result in damage.
CAUTION
Keep hands and fingers clear of the unit when
opening, closing, or adjusting the LCD panel. Be
especially cautious of children
’s hands and fin-
gers.
% Press OPEN/CLOSE to open the LCD
panel.
# To close the LCD panel, press OPEN/CLOSE
again.
Adjusting the LCD panel angle
Important
! If you can hear the LCD panel knocking
against your vehicle
’s console or dashboard,
press ANGLE (
–) to move the LCD panel a lit-
tle forward.
! When adjusting the LCD panel angle, be sure
to press ANGLE (+/
–). Forcibly adjusting the
LCD panel by hand may damage it.
% Press ANGLE (+/–) to adjust the LCD
panel to an easily viewable angle.
The LCD panel angle continues changing as
long as you press
ANGLE (+/
–) and hold.
# The adjusted LCD panel angle will be memor-
ized and automatically returned to the next time
the LCD panel is opened.
Turning the LCD panel horizontal
When the LCD panel is upright and it hinders
the operation of the air conditioner, the panel
can be turned horizontal temporarily.
% Press FLIP DOWN to turn the LCD panel
horizontal.
# To return to original position, press
FLIP DOWN again.
# The LCD panel returns to the original position
automatically with beeping sound 10 seconds
after operation.
Changing the wide screen mode
You can select a desired mode for enlarging a
4:3 picture to a 16:9 one.
% Press WIDE to select the desired set-
ting.
Press
WIDE repeatedly to switch between the
following settings:
FULL (full)
—JUST (just)—CINEMA (cinema)—
ZOOM (zoom)
—NORMAL (normal)
Operating this unit
En
18
Section
03