Philips 20PF - Manual (Page 12)

6
English The search starts automatically. All the
available TV programmes are stored. This
operation takes a few minutes. The display
shows the progress of the search and the
number of programmes found.
Important
: To exit or interrupt the search
before it is completed, press the H key.
If you interrupt search during auto store, not
all channels are stored. For all channels to
be stored, you need to do a complete auto
store search again.
Note
ATS (Automatic Tuning System) feature
If the transmitter or cable network sends the
automatic sort signal, the programmes are
numbered correctly. In this case, the installation
is complete. If this is not the case, you can use
the Sort menu to number the programmes
correctly.
ACI (Automatic Channel Installation)
feature
If a cable system or a TV channel which
broadcasts ACI is detected, a programme
list appears. Without ACI broadcast, the channels
are numbered according to your language and
country selection. You can use the Sort menu to
re-number them.
Some transmitters or cable networks broadcast their
own sort parameters (region, language, etc.). In this
case, indicate your choice using the О п keys and
confirm with Æ
key.
Programme Sort
Press the H key. The TV Menu is
displayed on the screen.
Use the ï key, select the Install menu
and the Æ key to enter the Install menu.
Use the ï key to select Sort and the Æ key
to enter sort mode.
Select the programme number you want to
move by using the О п keys and the Æ key
to enter sorting mode. (The arrow cursor
now points to the left.)
Use the О п keys to select the new
programme number and confirm with the Í
key. (The arrow points to the right and
sorting is completed.)
Repeat steps and for each
programme number you wish to re-number.
To exit the menu, press the Ë key.
1
4 5
4
3
5
6
2
7
Plug’n’Play
Country
Í GB Æ
Language
English
TV Menu
Picture
Sound
Features
Install
Install
Language
Country
Auto Store
Manual Store
Sort
Name
Ж • 0
Ж • 1
Ж • 2
Ж • 3 Ж
Ж • 4
Ж • 5
Quick Installation
When you switch on the TV set for the
first time, a menu is displayed on screen.
This menu prompts you to select the
country and language for the menus.
Note
If the above menu is not displayed, proceed to
do the installation of channels by the
Auto Store method (see page 7). If the
above menu is displayed, proceed to do the
following steps.
& Use the О п keys on the remote control
to select your country. If your country does
not appear in the list, select “. . . “ . Refer to
the “Reference table of Countries available for
selection” on page 22.
é Use the Æ key to move to the Language
mode and select your language with the О п
keys.
“ Use the Æ key to start search.