Planet Technology SOHO Internet Telephony PBX System IPX-600 - Manual (Page 59)

configuring IPX-600 to do the PSTN call:
a. Configure the FXO gateway to register to IPX-600. If the FXO gateway registered to IPX-600
with the registered number as 0, then, any extension IP Phone can dial 0# to first connect to
the gateway, and then dial the desired PSTN number. This is a two-stage dialing.
b. If you want to configure a one-stage dialing, a call route with destination IP address pointed to
the FXO gateway must be added in the “Call Route” list. The following figure shows the
example configuration. In this way, the FXO gateway does not need to register to IPX-600.
Figure 65. Gateway example page
Figure 66. Call route example page
59