Planet Technology SOHO Internet Telephony PBX System IPX-600 - Manual (Page 31)

Figure 29. The relationship of call group and pickup group
As shown in Figure 29, IP Phone #103 belongs to call group #1 and #2, suppose that its pickup
group is #1, and then it can only pickup the calls of #101, #102 and #104. And suppose that IP Phone
#101 has pickup groups #1 and #2, and then it can pickup calls of every IP Phones in this figure.
11. Call Type: IPX-600 will automatically detect whether the IP Phone is registered from this office
(displayed “local”) or from another office (displayed “remote”).
12. IP: Port: This field will show the IP address and port number of the registered IP Phone.
13. APS: The field when set to “YES” will enable the auto-provisioning (auto-installation) of this
specific IP Phone, the IPX-600 will give the user accounts to the specific IP Phone (identified by
the MAC address), and thus the IP Phones could be installed without any configuration.
14. VMWI (new/old): The number of new and old voice mails of this extension IP Phone.
The following sections will detail the possible installation methods (manually or automatically) of
IPX-600 and IP Phones step by step:
¾ Install IP Phone Automatically
If you purchased a batch of IP-Phones with the IPX-600 at the same time, you can install all these
IP Phones automatically without doing any configuration on each IP Phone, you just need to do some
configurations on IPX-600 only.
The following steps will lead you to do this automatic installation step by step:
1. Click on Batch Add button, and the following page will appear.
31