Promise Technology FastTrak S150 - Manual (Page 47)

Chapter 4: Installing Software Drivers
43
Existing Windows 98 Installation
The following section details the installation of FastTrak TX4 drivers on a system
that has Windows 98 already installed and running.
1. After installing the FastTrak S150 TX4 controller card and configuring the
hard drives, power up the system and boot Windows.
2. The “Add New Hardware Wizard” will appear, informing you that it has
found a “PCI Mass Storage Controller.”
3. Click Next. From the generated list box, choose Search for best driver for
your device (Recommended).
4. Click Next. From PCI Mass Storage Controller choose Finish.
5. Insert the FastTrak TX4 driver diskette in drive A:.
6. Click Next. From the generated choices, choose Specify a location.
7. Type A:\WIN98-ME in the text box that appears.
8. Click Next. A message informing you that Windows has found “Win98-ME
Promise FastTrak TX4000/S150 TX Series Controller” should appear.
9. Click Next, then click Finish.
10. Click Yes when asked if you want to restart your computer. Be sure to eject
the diskette from drive A:.
Confirming Windows 98 Driver Installation
To confirm that the driver has been properly loaded in Windows 98, perform the
following steps:
1. Choose Settings from the Start menu.
2. Choose Control Panel, then double-click the System icon.
3. Choose the Device Manager tab, then click the “+” in front of SCSI
controllers. “Win98-ME Promise FastTrak TX4000/S150 TX Series
Controller” should appear.