Promise Technology FastTrak S150 - Manual (Page 41)

Chapter 4: Installing Software Drivers
37
Existing Windows 2000 Installation
After installing the FastTrak S150 TX4 card and rebooting your system,
Windows 2000 setup will show a “New Hardware Found” dialog box. Under
Windows 2000, “PCI Mass Storage Controller” will be displayed.
1. Choose Add New Hardware Wizard from the list, and then press Enter.
2. Choose Add/Troubleshoot a device and click Next. The new hardware
wizard will show device list
3. Choose Mass Storage controller and click Next. At the following screen click
Finish.
4. Choose Display a list the known drivers for this device so that I can choose
a specific driver then click Next.
5. When the Windows 2000 supported SCSI adapter drivers list appears, click
Have disk.
6. Insert the FastTrak TX4 driver diskette in drive A:\.
7. Type A:\Win2000 in the text box. Click OK.
8. Choose Win2000 Promise FastTrak TX4000/S150 TX Series Controller
from the list that appears on screen, then click Next.
9. Click Yes to confirm continue the installation and copy the driver to system.
10. Remove the diskette and click Finish to restart the system. Windows 2000
will then restart for the driver installation to take effect.
Confirming Windows 2000 Driver Installation
1. Right-click on the My Computer icon and select Manage from the popup
menu.
2. From the left panel, select Device Manager.
3. Click the “+” in front of SCSI controllers. “Win2000 Promise FastTrak
TX4000/S150 TX Series Controller” should appear.