Philips DCR 2020 - Manual (Page 5)

4
To avoid incorrect insertion of the smart card in the
slot, make sure you affix the reminder sticker
supplied with your receiver on the smart card so as
to cover the following text:“Deze zijde boven” (on
the side that has no chip).
5
Insert your smart card in your receiver with the
golden or silver contacts facing up.
6
Insert the two batteries supplied in your remote
control.
Batteries are removable from the remote using
common household tools (like a screwdriver,…).
The batteries supplied do not contain hazardous
substances such as Mercury, Cadmium, or Lead.
However, they must not be disposed of with your
household waste but to a local separate collection
system.
7
Reconnect your TV set and recorder to the mains.
Do not connect your receiver yet!
8
Switch on your TV set and select a channel.
9
Plug the receiver’s power cord to the mains.The
welcome screen appears, then the First installation
screen.
10
Set your favourite menu language and press OK.
11
Set appropriate values for the following:
• Network ID: applicable network ID as indicated
by your operator. Please see operator booklet for
the right decimal value to be entered for your
region.
• Frequency: broadcast frequency predefined or
entered manually as indicated by your operator
(please see operator booklet).
• Symbol Rate: predefined value, which should not
be modified unless requested by your operator
• Modulation: predefined modulation type, which
should not be modified unless requested by your
operator
Symbol rate and modulation may be modified
manually upon request by your operator.
12
Press OK to start scanning for channels.
When scanning has been successfully completed, a
completion message is displayed, and then the receiver
tunes to the first channel in the list.
39
EN
DCR 2020_indice1 1/09/05 15:26 Page 39