beautypg.com

66 troubleshooting, Troubleshooting – Philips DCR 2020 User Manual

Page 32

background image

EN

The display on the front

panel does not light up.

No sound or picture but the

front panel red light is on.

No sound or picture but the

front panel green light is on.

The remote control does not

operate your receiver.

On-screen display working

but there is no reception

Intermittent reception

The picture is not sharp and

on-screen text is difficult to

read.

You cannot find all the

channels you think should be

available.

Faulty power supply

Receiver in standby or “low

power”

Poor signal

Receiver in TV mode

Poor SCART connections

Poor reception/signal

Faulty connections

TV SCART output format not

set to RGB

TV SCART not connected to the

RGB capable SCART socket of

your TV set

Inappropriate TV SCART

The signal may be weak.

Check that the power cord is

correctly connected. Disconnect

this cord and reconnect it to

ensure it is in place.

Check that the power is available at

the wall socket.

Press P+, P-, or any number key of

the remote control. If the receiver

does not wake up, press

on the

front panel.

Check the connections at the wall

socket and receiver.

Press TV/STB on the remote

control once or twice.

Check the SCART connections.

Make sure the receiver is on.

Make sure you are pointing your

remote control at the receiver

front panel.

Check the batteries in your remote

control.

Check the installation.

Check all connections and cable.

Change setting of the TV output

signal item to RGB from the TV

Configuration screen.

Refer to your TV User Manual.

Use the SCART cable supplied with

your receiver.

Try retuning your receiver, following

the relevant steps in paragraph

Channels installation. If you are still

missing channels, call your customer

service adviser.

66

Troubleshooting

Problem

Possible cause

Action

DCR 2020_indice1 1/09/05 15:26 Page 66