beautypg.com

61 setup, Setup, Channels installation – Philips DCR 2020 User Manual

Page 27: Signal test, Tv configuration

background image

61

EN

Setup

Setup is used to:

• Install channels

• Test signal level and quality

• modify the general settings of your receiver

• check for software updates

• restore the receiver factory settings.

Access to this menu can be protected by Pin Code.

Channels installation

- Select appropriate values for the following:

Network ID: applicable network ID as indicated

by your operator. See operator booklet for the

right decimal value to be entered for your region.

Frequency: broadcast frequency predefined or

entered manually as indicated by your operator

(see operator booklet).

Symbol Rate: predefined or entered manually as

indicated by your operator.

Modulation: modulation type predefined or

entered manually as indicated by your operator.

Symbol rate and modulation values should not be

modified unless requested by your operator.

- Press OK to start scanning for channels.

Signal Test

Signal Test is used to view the signal level and quality for

the frequency defined at installation.

TV Configuration

Select appropriate values for the following:

TV Format: 4:3 or 16:9

TV aspect ratio: full format, 16:9 Letter Box, 4:3

Center

TV output signal: CVBS, RGB, or S Video

TV audio signal: Stereo, Mono, or Dolby Digital.

VCR Video Output: CVBS or S Video

VCR Recording control: NO, PREPARE

RECORD, or RECORD LINK. See chapter More

about recording (VCR or DVD control).

Video mode: PAL or SECAM

- Press OK to store the settings.

DCR 2020_indice1 1/09/05 15:26 Page 61