Phantom Tech Sure View SU0508L - Manual (Page 9)

Cutting the
Screen Housing Assembly
It is easy to cut right through the Screen Housing Assembly
of the Sure View Screen using a chop saw or hacksaw.
NOTE: All cutting will be done on the upper end
of the Screen Housing Assembly. The Mounting
Bracket on the Screen Housing Assembly is
clearly labeled with CUT and NO CUT zones.
1. Remove the Mesh Lock Adjuster and Sliding
Bar Top Cap from the Screen Housing Assembly by
removing their screws with a Phillips screwdriver. (A)
2. Detach the Sliding Bar from the Sliding Bar Bottom Cap,
and slide it towards the upper end of the Screen Housing
Assembly until it is aligned with the top of the Assembly
and the mesh. (B)
3. Slide the Mounting Bracket until its upper edge
is aligned with the upper edge of the Screen
Housing Assembly. (C)
4. With all components aligned, carefully
measure and mark the Screen Housing,
Sliding Bar and Mounting Bracket on all
sides based on the “Length to be cut” dimension
calculated on Page 7. (D)
5. Wearing safety glasses, cut straight through
all components of the assembly. Use a file to
remove any burrs from the cut surfaces.
6. Re-attach the Sliding Bar onto the Sliding
Bar Bottom Cap. (B) Make sure that it is
pushed in as far as it will go.
7. Re-attach the Mesh Lock Adjuster and Sliding Bar
Top Cap to the Screen Housing Assembly and
replace the screws. (A)
8. Slide the Mounting Bracket completely off the
Screen Housing and set aside.
9
Catch Frame
Length
to be cut
D
C
B
A