Pioneer DVR-540H-S - Manual (Page 112)

The Initial Setup menu 14
112
En
When recording dual mono audio to DVD in VR mode (except in LPCM mode), or to HDD with HDD Recording
Format set to Video Mode Off (except in LPCM mode), both audio channels are recorded and you can switch to the
one you want on playback.
Audio Out
Digital Out On • Activates the digital audio output.
Off Deactivates the digital audio output.
When set to Off , all the following Audio Out settings are grayed out.
Dolby Digital Out Dolby Digital • Output a Dolby Digital signal when a Dolby Digital
source is being played.
Dolby Digital
PCM
Convert Dolby Digital sources to Linear PCM output.
Use if your connected equipment doesn’t have a
Dolby Digital decoder.
DTS Out On • Output a DTS signal when a DTS source is being
played.
Off Switch off the digital output when a DTS source is
being played. Use when your connected equipment
doesn’t have a DTS decoder. In this case, use the ana-
log audio outputs.
96 kHz PCM Out 96 kHz 48 kHz • Convert 96 kHz digital audio sources to 48 kHz out-
put. Use if your connected equipment doesn’t sup-
port 96 kHz sampling rate.
96 kHz Output 96 kHz digital audio when a 96 kHz source is
being played.
MPEG Out MPEG Output an MPEG audio signal when a source using
MPEG audio is being played.
MPEG PCM • Convert sources with MPEG audio to Linear PCM out-
put. Use if your connected equipment doesn’t have
an MPEG audio decoder.
Audio DRC On Switches on Audio DRC (Dynamic Range Control).
Use when listening to Dolby Digital material at low
volume.
Off • Switches off Audio DRC.
Audio DRC is not effective when listening via the digital output when the Dolby Digital Out setting is set to Dolby
Digital .
Setting Options Explanation
DVR640H_KU_EN.book 112 ページ ２００６年３月７日 火曜日 午後３時１８分