beautypg.com

Installing or replacing batteries power supply, Charging and discharging batteries, Test – Philips Zenia Voice 6326 User Manual

Page 13

background image

Installation

10

Installing or replacing batteries

Power supply

Your telephone handset is powered by two rechargeable NiMh batteries, type AAA/
R03.

When replacing the batteries, please use the following model: PHILIPS
MULTILIFE R03NM, or PANASONIC 650 mAh.

• Press the top of the battery compartment lid

and slide it down.

• Insert new batteries according to the marking.
• Slide the lid back in place.

NiMh batteries must be disposed of in accordance with applicable waste disposal
regulations.

: Never use non-rechargeable batteries, and only use recommended models.

The manufacturer disclaims responsibility if these recommendations are not
followed.

Charging and discharging batteries

On first use or when new batteries have been inserted, charge the batteries for
at least 12 hours. This precaution will prolong battery life.

A symbol located at the top of the display will appear permanently to indicate the
battery charging status.

Each bar of the

symbol represents about 1/3 of maximum charging capacity.

While the batteries are being charged, the charge indicator

flashes and shows

the following symbols in sequence

. When the

symbol is

displayed, the batteries are fully charged.

: The charging status indicator is only relevant after the first charging cycle

has been completed.

: After a complete discharge of the batteries, the symbol only appears after a

few minutes of charge.

If the

symbol is displayed, batteries need charging. During a call, the handset

switches off after a few minutes.

Test

When the handset and the base station have been installed, proceed as follows to
make a call:

• Make sure the

A symbol on the display is visible (if not, register the handset to

the base station (see “2.7 Registering a handset to a base station”, page 41).

• Press the

key; the

t symbol is displayed and you hear the tone.

• Dial a number; the figures appear on the display and the number is dialled

automatically.

If a problem occurs during this test, check the battery charging status (see
“Charging and discharging batteries”, page 10), the charging unit and the
connection of the base station to the telephone line and the wall socket.

prelim-zenia.book Page 10 Mardi, 20. juin 2000 10:31 10