Polycom SpectraLink 1725-36038-001 User Manual

Page 35

SpectraLink Wireless Telephone Configuration

PN: 1725-36038-001_B.doc

Use

g only

if all of your infrastructure devices use only 802.11g. The

handsets will operate up to 54 mb/s in this mode.

Use

b & b/g mixed

if some of your infrastructure components only

understand 802.11b. The handsets will operate up to 11 mb/s.

Subbands have not been established for the

b and b/g mixed

or the

g only

mode at this writing. Provision is made in the software to

accommodate these ranges once established. Newly added
subbands may not appear in the above table.

Subband

Once a mode is set the subband list will display, if applicable.
Only those ranges which are allowed in the set regulatory domain
and that pertain to the set mode are displayed. Note that for
802.11a the bands labeled

DFS

will vary depending on the set

regulatory domain. Multiple subbands may be set. Navigate to the
desired subband and set with

NavOK.

The

Transmit Power

will open. Once the

Transmit Power

setting is done, you will be

returned to the subband list.
To deselect a subband, navigate to it and press

NavOK

Once the subband settings are as desired, press the

Done

softkey to

exit to the

Network Setup

menu.

Transmit power

For subbands:

The

Transmit Power

list opens when

NavOK

pressed from the

Subband

menu. A transmit power setting is

required for each subband. Only one level may be set per
subband. Only those power levels which apply to the
regulatory domain and 802.11 mode are listed. Navigate to the
desired level and press

NavOK

to set and return to the subband

list. Another subband may be selected which repeats the
process.
If the highlighted power transmit level is legal on all of the
subbands for the set mode, an

All

softkey will appear. Press the

All

softkey to apply that level to all subbands and return to the

subband menu where all subbands will now be selected.

All

overrides any previously set power transmit levels.

Without subbands:

When the 802.11 mode has no subbands, the

Transmit Power

list opens when

NavOK

is pressed to set the

mode. Only those power levels which apply to the domain