Pioneer DVR-531H-S - Manual (Page 108)

Additional information 14
108
En
On-screen displays and recorder displays
The table below shows a list of error messages that you may encounter when using the recorder and an explanation
of their meaning.
Message Explanation/Action
• Initializing disc. Please wait a moment. When you load a blank DVD-RW disc, the recorder automatically
initializes it.
• Incompatible region number. The disc loaded has an incompatible region number for the
recorder and so will not play.
• Cannot record any more titles.
• No more space for file management data.
• Cannot add any more chapter marks. The disc control data limit has been reached, or the maximum
number of chapters and/or titles has been reached. Erase titles/
chapters or combine chapters.
• This disc cannot be recorded. Undo the final-
ization. The disc was finalized on a non-Pioneer DVD recorder. Undo the
finalization in order to recording/editing.
• Cannot play this disc.
• This disc cannot be recorded.
• Cannot read the CPRM information.
• Could not record the information to the disc.
• Cannot edit.
• Could not initialize disc.
• Could not complete finalization successfully.
• Could not undo finalization successfully.
• Could not successfully unlock the disc. The disc may be dirty or damaged. Take out the disc, clean it and
retry. If the error persists, use a new disc. If the error appears even
with a new disc, please consult a Pioneer Service Center.
• Incompatible or unreadable disc. The disc loaded is a DVD+R/RW, DVD-RAM or some other
incompatible disc type. This display may also appear if the disc is
dirty or damaged.
• Cannot record to a disc that is not CPRM com-
patible.
• Cannot record this content using Video mode
recording. The video source is copy-once protected. Use a VR mode DVD-R/
RW disc with CPRM for recording.
• This content is copy protected. The video source is copy-protected and cannot be recorded.
• Incorrect CPRM information. The recorder could not read the CPRM information. The recorder
may be damaged—please consult a Pioneer Service Center.
• The audio will conform to the [Dual Mono
Recording] setting. When recording from an external input in Video mode (DVD), Video
Mode On (HDD), or in LPCM mode, you can only record the left or
right channel; not both.
• Repairing disc. During recording, the power was cut. This display appears when
the power is restored.
• Could not repair the disc. The recorder was unable to repair the disc after a power cut. The
contents of the recording will be lost.
• Overheating has stopped operation.
Press DISPLAY to clear this message. The internal temperature of the recorder has exceeded the
operating limit. If this message reappears, please contact a
Pioneer authorized service center.
• There is no DV input or the input signal is unre-
cordable.
• Cannot preview because there is no DV input
or the input signal is unrecordable. No signal was detected at the DV IN jack. This may appear if a
blank section of DV tape is playing in the connected camcorder.
DVR-530H_KU.book 108 ページ ２００５年６月８日 水曜日 午前１１時１６分