Planar Dome EX - Manual (Page 39)

Single Desktop | 29
To change the configuration to single desktop
If you are working on a dual-headed display, you can use the
following procedure to change your hardware and software
configuration to single desktop.
1 Use the InstallShield Wizard to uninstall the existing driver.
2 On the DIP switch, place switch 3 in the ON position.
3 Reinstall the display controller. Then attach both displays to
the controller.
4 Power on the system, and run Setup.exe to install the driver.
5 Set the display resolution.
To get information
Open the Dome tab to retrieve information on the two displays you
are using to run single desktop. Information for both left and right
panels appears at the bottom of the Dome tab.
Restoring dual heads
To return to dual-headed display, follow the procedure above but
place switch 3 on the DIP switch in the OFF position. Then set the
display resolution.