Philips Mini-ITX Mainboard EPIA-MII - Manual (Page 51)

Chapter 3
3-16
SuperIO Device
Press Enter to enter the sub-menu and the following screen appears:
Onboard FDC Controller
Enable the onboard floppy controller. Select
Enabled when you have
installed a floppy disk drive. Settings: Enabled , Disabled
Onboard Serial Port 1/2
Set the base I/O port address and IRQ for the onboard serial port A/serial
port B. Selecting
Auto allows BIOS to automatically determine the
correct base I/O port address. Settings:
Onboard Parallel Port
This specifies the I/O port address and IRQ of the onboard parallel port.
Settings:
Disabled, 378/IRQ7, 278/IRQ5 , 3BC/IRQ7
Parallel Port Mode
Set the parallel port mode. To operate the onboard parallel port as
Standard Parallel Port, choose
SPP . To operate the onboard parallel port
in the EPP mode, choose EPP . By choosing ECP , the onboard parallel port
will operate in ECP mode. Choosing ECP + EPP will allow the onboard
parallel port to support both the ECP and EPP modes simultaneously.
Settings:
SPP, EPP, ECP, ECP + EPP
Port Settings
1 Disabled 3F8/IRQ4 2F8/IRQ3 3E8/IRQ4 2E8/IRQ3 Auto
2 Disabled 3F8/IRQ4 2F8/IRQ3 3E8/IRQ4 2E8/IRQ3 Auto