Paradyne 6212-I1 - Manual (Page 23)

2. Hardware Installation and PC Setup
6212-A2-GB23-00 September 2005 2-7
Windows 2000
1. In the Windows task bar, click on the Start button, point to Settings, and then
click on Control Panel.
2. Double-click on the Network and Dial-up Connections icon.
3. In the Network and Dial-up Connections window, right-click on the Local Area
Connection icon, and then select Properties.
The Local Area Connection Properties dialog box display a list of currently
installed network components. If the list includes Internet Protocol (TCP/IP),
the protocol has already been enabled; skip to
Step 10 .
4. If Internet Protocol (TCP/IP) does not appear as an installed component, click
on Install.
5. In the Select Network Component Type dialog box, select Protocol, and then
click on Add.
6. Select Internet Protocol (TCP/IP) in the Network Protocols list, and then click
on OK.
You may be prompted to install files from your Windows 2000 installation CD
or other medium. Follow the instructions to install the files.
7. If prompted, click on OK to restart your computer with the new settings.
8. After restarting your PC, double-click on the Network and Dial-up Connections
icon in the Control Panel.
9. In Network and Dial-up Connections window, right-click on the Local Area
Connection icon, and then select Properties.
10. In the Local Area Connection Properties dialog box, select Internet Protocol
(TCP/IP), and then click on Properties.
11. In the Internet Protocol (TCP/IP) Properties dialog box, click on the radio
button labeled Use the following IP address. Type an address between
192.168.1.3 and 192.168.1.254 in the IP Address field and 255.255.255.0 in
the Subnet Mask field.
12. Click on OK twice to confirm and save your changes, and then close the
Control Panel.
Windows ME
1. In the Windows task bar, click on the Start button, point to Settings, and then
click on Control Panel.
2. Double-click on the Network and Dial-up Connections icon.
3. In the Network and Dial-up Connections window, right-click on the Network
icon, and then select Properties.
The Network Properties dialog box displays a list of currently installed network
components. If the list includes Internet Protocol (TCP/IP), the protocol has
already been enabled; skip to
Step 11 .