beautypg.com

4 connecting the 10/100base-t ethernet interface, Connecting the 10/100base-t ethernet interface, Er to section 3.4, “connecting the – Patton electronic 2158 User Manual

Page 11

background image

11

The

terminal block connector

on the CopperLink Ethernet Extender's

twisted pair interface

is polarity insensitive

and is wired for a two-wire

interface. The signal/pin relationships is shown in Figure 5.

Figure 5.

CopperLink Ethernet Extender twisted pair line interface.

3.4 CONNECTING THE 10/100BASE-T ETHERNET INTERFACE

The shielded RJ-45 port labeled

Ethernet

is the 10/100Base-T interface.

This port is designed to connect directly to a 10/100Base-T network.
Figure 6 shows the signal/pin relationships on this interface. You may
connect this port to another Ethernet device via a Type 4 or Type 5 cable
that is up to 328 ft long.

Figure 6.

CopperLink Ethernet Extender 10/100Base-T RJ-45 Connector Pinout.

See also other documents in the category Patton electronic Hardware: