Philips - FW768P - Manual (Page 28)

28
English
TIMER SLEEPTIMER
Timer Setting
• The system can switch on to CD,
TUNER, or TAPE 2 mode automatically
at a preset time. It can serve as an
alarm to wake you up.
• Before setting the timer, make sure the
clock is set correctly.
• The timer will always be switched on
once it is set.
• The volume of the timer will start to
increase from the minimum level
until the volume level before the set
is switched to standby mode.
1 Press and hold CLOCK/TIMER for more
than two seconds to select timer mode.
™ “AM 12:00” or the last set timer
starts flashing. The TIMER flag
flashes.
™ The last selected source is lit while
other available sources are flashing.
2 Press CD, TUNER or TAPE to select
the desired source.
• Before selecting CD or TAPE, make sure
a CD or tape is loaded in the CD tray or
tape deck 2.
3 Press␣ à or á to set the hour for the
timer to start.
4 Press␣ í or ë to set the minute for
the timer to start.
5 Press CLOCK/TIMER to store the start
time.
™ The timer is now set.
™ The
TIMER flag remains on the display.
• At the preset time, the timer will be
activated.
™ The selected source will be played.
Notes:
– During timer setting, if no button is
pressed within 90 seconds, the system
will exit timer setting mode
automatically.
– If the source selected is TUNER, the last
tuned frequency will be switched on.
– If the source selected is CD, playback
will begin with the first track of the last
selected disc. If the CD trays are empty,
the TUNER will be selected instead.
– If the source selected is TAPE, and if the
preset time is reached during high
speed dubbing, the TUNER will be
selected instead.
To switch off the TIMER
1 Press CLOCK/TIMER for more than two
seconds.
2 Press Ç on the system to cancel the
timer.
™ The timer is now switched off.
™ The display will show "OFF" and the
TIMER flag disappears.
To start the TIMER again (for the same
preset time and source)
1 Press CLOCK/TIMER for more than two
seconds.
1 Press CLOCK/TIMER again to store the
start time.
™ The timer is now switched on.
™ The
TIMER flag appears on the display.
Sleep Timer (only on remote control)
This feature allows you to select a length
of time after which the system will switch
to the standby mode automatically.
• Press SLEEP TIMER on the remote
control repeatedly to select a period of
time.
™ The selections are as follows (time in
minutes):
60 ™ 45 ™ 30 ™ 15 ™ OFF ™
60 …
™ “SLEEP XX” or “OFF” will be
displayed. " XX" is the time in
minutes.
• When you reach the desired length of
time, stop pressing the SLEEP TIMER
button.
™ After this amount of time passes, the
system will switch to the standby
mode.
To switch off the Sleep Timer
• Press SLEEP TIMER repeatedly until
" OFF" is displayed, or press the
STANDBY ON button.