Philips - FW768P - Manual (Page 23)

23
English
TUNER
™ The system will search for every
available station in the FM waveband
first, then search the AM waveband.
™ All available stations will be stored
automatically. The frequency and
preset number will be displayed
briefly.
™ The system will stop searching when
all the available radio stations are
stored or when the memory for 40
preset radio stations is used.
™ The system will remain tuned to the
last stored preset radio station.
Notes:
– You can cancel the automatic
programming by pressing PROGRAM or
STOP•CLEAR Ç (on the system only).
– If you want to reserve a section of
preset numbers, for example preset
numbers 1 to 9, select preset 10 before
starting automatic programming; only
the preset numbers 10 to 40 will be
programmed.
Manual programming
1 Press TUNER (FM•AM).
2 Press TUNER (FM•AM) again to select
the desired waveband : FM or AM.
3 Press PROGRAM for less than one
second.
™ The
PROGRAM flag starts flashing.
™ The next available preset number will
be displayed for selection.
4 Press TUNING à or á to tune to the
desired frequency.
• If you wish to store the radio station to
another preset number, press PRESET
4 or 3 to select the desired preset
number.
5 Press PROGRAM again.
™ The PROGRAM flag disappears and the
radio station will be stored.
• Repeat the steps 3 – 5 to store other
preset radio stations.
Notes:
– When 40 radio stations are stored and
you attempt to store another radio
station, the display will show
"FULL”. If you want to change an
existing preset number, repeat steps 3 –
5.
– You can cancel manual programming by
pressing STOP•CLEAR Ç (on the
system only).
– During programming, if no button is
pressed within 20 seconds, the system
will exit program mode automatically.
Tuning to Preset Radio
Stations
• Press PRESET 4 or 3 to select the
desired preset number.
™ The preset number, radio frequency,
and waveband appear on the display.