Philips - FW768P - Manual (Page 26)

26
English
RECORDING
Notes:
– For recording, use only tape of IEC type I
(normal tape) or IEC type II (Cr02).
– The tape is secured at both ends with
leader tape. At the beginning and end of
tape, nothing will be recorded for six to
seven seconds.
– The recording level is set automatically,
regardless of the position of Volume,
DBB or DSC.
– To prevent accidental recording, break
out the tab on the left shoulder of the
tape side you want to protect.
– If “CHECK TAPE” is displayed, the
protection tab has been broken. Put a
piece of clear adhesive tape over the
opening. Do not cover the Cr02 tape
detection hole when covering the tab
opening.
Recording from other sources
(only on tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load a blank tape into tape deck 2 with
the open side downward.
3 Press SIDE on remote control to select
the recording side.
™ The
BACK or FRONT flag will be
displayed, depending on the side
selected.
4 Press A. REV to select the playback
mode ( е е е е е or ∂ ∂ ∂ ∂ ∂ ).
5 Press CD, TUNER or AUX.
• Start playback of the selected source.
TIMER STEREO
FM
BACK HSD REPEAT
LW MW AM T.A. NEWS
SOUND NAVIGATION
DIGITAL SOUND
CONTROL
DYNAMIC BASS
BOOST
TAPE CD
PROG
CLOCK/
TIMER NEWS!
RDS
DOLBY B
NR
DUB
(HSD)
REC
STANDBY
ON
SIDE A•B A.REV
TUNER AUX
PRESET ▲ ▲
STOP • CLEAR SEARCH • TUNING PLAY PAUSE PREV NEXT
MINI HIFI SYSTEM
C D 1 • 2 • 3 CDR FM • AM TAPE 1 • 2
FRONT
60Hz 500Hz 250Hz 1KHz 2KHz 4KHz 8KHz
VOLUME
REC SHUFFLE PROGRAM
S S
L R
C
PRO LOGIC
SWITCH OFF DOLBY PRO LOGIC WHEN RECORDING
6 Press REC to start recording.
™ The REC flag starts flashing.
7 Press Ç to stop recording.
Notes:
– Only
е е е е е or ∂ ∂ ∂ ∂ ∂ mode is available
during recording .
– During recording, it is not possible to
listen to another source.
Dubbing tapes (from tape deck 1 to
tape deck 2)
1 Press TAPE ( TAPE 1•2 ) to select tape
deck 2.
2 Load the prerecorded tape into tape
deck 1 and a blank tape into tape deck
2.
™ Make sure that both tapes have their
full spool to the left.
3 Press SIDE on the remote control to
select the recording side.
4 Press DUB (HSD) once for normal
speed dubbing or twice (within 2
seconds) for high speed dubbing.
™ “NORMAL” (normal speed) or
“ FAST” (high speed) will be
displayed, followed by
“
DUBBING”.
™ The HSD flag appears on the display
during high speed dubbing.
• Dubbing will start immediately.
™ The REC flag starts flashing.
5 Press Ç to stop dubbing.