Philips - FW768P - Manual (Page 27)

27
English
Notes:
– At the end of side A, flip the tapes to
side B and repeat the procedure.
– Dubbing of tapes is only possible from
tape deck 1 to tape deck 2.
– To ensure good dubbing, use tapes of
the same length.
– During high speed dubbing in Tape
mode, the sound is reduced to a low
volume.
– You can listen to another source while
dubbing.
CD Synchro Start Recording
1 Load a blank tape into tape deck 2 and a
disc into a disc tray.
2 Press CD to select CD mode.
• You can program the tracks in the order
you want them to be recorded (see
Programming Tracks). If you do not, the
tracks are recorded according to the
order on the selected disc.
3 Press REC to start recording.
™ The REC flag starts flashing.
• CD will start playback automatically.
4 Press Ç to stop recording.
RECORDING CLOCK
One Touch Recording
• For One Touch Recording, as soon as you
press REC, the current source (CD,
TUNER or AUX) will be recorded on tape
deck 2.
1 Load a blank tape in tape deck 2.
2 Press REC to start recording.
™ The REC flag starts flashing.
3 Press Ç to stop recording.
Note:
– When you press RECORD while in TAPE
mode, "SELECT SOURCE" will be
displayed. One Touch Recording is not
possible in TAPE mode.
SHUFFLE PROGRAM
FM
STEREO BACK HSD REPEAT REC LW MW AM T.A. NEWS
SOUND NAVIGATION
DIGITAL SOUND
CONTROL
DYNAMIC BASS
BOOST
TAPE CD
PROG
CLOCK/
TIMER NEWS!
RDS
DOLBY B
NR
DUB (HSD)
REC
STANDBY
ON
SIDE A•B A.REV
TUNER AUX
PRESET ▲ ▲
STOP • CLEAR SEARCH • TUNING PLAY PAUSE PREV NEXT
MINI HIFI SYSTEM
C D 1 • 2 • 3 CDR FM • AM TAPE 1 • 2
TIMER FRONT
60Hz 500Hz 250Hz 1KHz 2KHz 4KHz 8KHz
VOLUME
S S
L R
C
PRO LOGIC
View Clock
You can view the clock (if it is set) while
the system is in standby mode or any
source mode. It will be displayed for about
seven seconds.
• Press CLOCK/TIMER briefly (on the
system only).
™ “PM 10:38” (the current time)
will be displayed.
™ “--:--” will be displayed if the
clock is not set.
Clock Setting
The clock is set in 12-hour mode, e.g. “ AM
12:00“ or “PM 12:00“. Before
setting the clock, you must be in the View
Clock mode.
1 Press CLOCK/TIMER to select clock
mode.
™ “AM 12:00” or the current time
starts flashing.
2 Set the hour with␣ à or á.
3 Set the minute with␣ í or ë.
4 Press CLOCK/TIMER again to store the
setting.
™ The clock starts.
• To exit without storing the setting, press
Ç on the system.
Notes:
– During clock setting, if no button is
pressed within 90 seconds, the system
will exit clock setting mode
automatically.
– When a power interruption occurs, the
clock setting is erased.