beautypg.com

Messages, Understanding auto ta and eq error, Understanding built-in cd player error messages – Pioneer SUPER TUNER III D DEH-P8850MP User Manual

Page 69: Understanding auto ta and eq error messages, Additional information, English

background image

Black plate (69,1)

Understanding built-in CD
player error messages

When you contact your dealer or your nearest
Pioneer Service Center, be sure to record the
error message.

Message

Cause

Action

ERROR-11, 12,
17, 30

Dirty disc

Clean disc.

ERROR-11, 12,
17, 30

Scratched disc

Replace disc.

ERROR-10, 11,
12, 15, 17, 30,
A0

Electrical or me-
chanical

Turn the ignition
ON and OFF, or
switch to a differ-
ent source, then
back to the CD
player.

ERROR-15

The inserted disc
does not contain
any data

Replace disc.

ERROR-23

The CD format
cannot be played
back

Replace disc.

NO AUDIO

The inserted disc
does not contain
any files that can
be played back

Replace disc.

TRK SKIPPED

The inserted disc
contains WMA
files that are pro-
tected by DRM

Replace disc.

PROTECT

All the files on
the inserted disc
are secured by
DRM

Replace disc.

Understanding auto TA and
EQ error messages

When correct measurement of car interior
acoustic characteristics is not possible using
the auto TA and EQ, an error message may ap-
pear on the display. If an error message ap-

pears, refer to the table below to see what the
problem is and the suggested method of cor-
recting the problem. After checking, try again.

Message

Cause

Action

Check MIC
type

Microphone is
connected to mi-
crophone input.

Disconnect the mi-
crophone.

MIC ERROR

Microphone is
not connected.

Plug the supplied
microphone se-
curely into the
jack.

Front Speaker
ERROR, Front
left Speaker
ERROR, Front
right Speaker
ERROR, Rear
left Speaker
ERROR, Rear
right Speaker
ERROR, Sub-
woofer
ERROR, Sub-
woofer Lch
ERROR, Sub-
woofer Rch
ERROR

The microphone
cannot pick up
the measuring
tone of a speaker.

! Confirm that the
speakers are con-
nected correctly.
! Cancel muting
the front speaker
units.
! Correct the input
level setting of the
power amp con-
nected to the
speakers.
! Set the micro-
phone correctly.

Noise ERROR

The surrounding
noise level is too
high.

! Stop your car in
a place that is as
quiet as possible,
and switch off the
engine, air condi-
tioner or heater.
! Set the micro-
phone correctly.

69

Additional Information

En

69

English

Appendix