Pioneer DEH P4200UB - Manual (Page 17)

To connect your cellular phone to this unit via Blue-
tooth wireless technology, you need to enter PIN code
on your phone to verify the connection. The default
code is
0000, but you can change this in this func-
tion.
With some Bluetooth audio players, you may be re-
quired to enter the Bluetooth audio player PIN code
in advance to set this unit for a connection.
! You can only operate this function when Blue-
tooth adapter (e.g. CD-BTB200) is connected to
this unit.
1 Push M.C. up or down to select a number.
2 Push M.C. left or right to move the cursor to the
previous or next position.
3 After inputting PIN code (up to 16 digits), press
M.C.
PIN code can be stored in memory.
! When you press M.C. again on the same dis-
play, the PIN code you entered is stored in this
unit.
! Pushing M.C. right in the confirmation display
returns you to the PIN code input display, and
you can change the PIN code.
BT Version info. (Bluetooth version display)
You can display the system versions of this unit and
of Bluetooth module.
! You can only operate this function when Blue-
tooth adapter (e.g. CD-BTB200) is connected to
this unit.
1 Push M.C. left or right to display the information.
! Push M.C. left to switch to the version of the
Bluetooth module of this unit.
! Pushing M.C. right to switch to the system
version of this unit.
Other Functions
Using the AUX source
Up to two auxiliary devices such as VCR or
portable devices (sold separately) can be con-
nected to this unit. When connected, auxiliary
devices are automatically read as AUX sources
and assigned to
AUX1 or AUX2. The relation-
ship between AUX1 and AUX2 sources is ex-
plained below.
About AUX1 and AUX2
There are two methods to connect auxiliary de-
vices to this unit.
AUX1 source:
When connecting auxiliary device using a stereo
mini plug cable
% Insert the stereo mini plug into the
AUX input jack.
For more details, refer to the installation man-
ual.
This auxiliary device is automatically set to
AUX1.
AUX2 source:
When connecting auxiliary device using an IP-
BUS-RCA Interconnector (sold separately)
% Use an IP-BUS-RCA Interconnector such
as the CD-RB20/CD-RB10 (sold separately)
to connect this unit to auxiliary device fea-
turing RCA output.
For more details, refer to the IP-BUS-RCA Inter-
connector owner
’s manual.
This auxiliary device is automatically set to
AUX2.
# You can only make this type of connection if
the auxiliary device has RCA outputs.
Selecting AUX as the source
% Press SRC/OFF to select AUX as the
source.
# AUX cannot be selected unless the auxiliary
setting is turned on. For more details, refer to
AUX1/AUX2 (auxiliary input setting) on the pre-
vious page.
Turning the clock display on or off
% Press CLK/DISP OFF to select the desired
setting.
Clock off
—clock display—elapsed time dis-
play
Operating this unit
En
17
English
Section
02