Pioneer MILESTONE 12 - Manual (Page 147)

147
Integrator Mode
4) GAMMA Setting
This function sets the GAMMA characteristics for the video.
Factory setting: GAMMA 2.2
1 Enter the integrator mode.
(Refer to section 5.4.1, “About the Integrator Mode” (pg. 142).)
2 Select ‘PICTURE’.
3 Place the cursor on ‘GAMMA’ then press the [SET] button.
4 Press the [2/3] buttons to change the setting.
Each time a [ 2/3] button is pressed, the setting changes
as shown below.
Press the [SET] button to return to screen 3.
Note
• The GAMMA value is set based on Pioneer’s measurement standards.
• After adjusting the WHITE BALANCE, the WHITE BALANCE is not lost even when the GAMMA setting is changed.
I N T E G R AT O R I N P U T 1
ENTER
S C R E E N S E T U P O P T I O N
C O N T R A S T
P I C T U R E
: 1 2 8
: 0
: 0
: 1 2 8
SET EXIT MENU
: 2 . 0
B R I G H T N E S S
H . E N H A N C E
V . E N H A N C E
G AMMA
P I C T UR E R E S E T
W H I T E B A L A N C E
C O L O R D E T A I L
Screen
3
G A M M A :
SET SET EXIT MENU
2 . 0
Screen
4
31.8
2.2 2.3 2.4
2 2 2
1.9 2.0 2.1
3 3 3 2 2 2 2
3 3 3