Pioneer DVR-640H-S - Manual (Page 42)

Recording 05
42
En
In this area you can set:
Record to – Select HDD for hard disk
recording or DVD for DVD recording. Select
HDD for Auto Replace Recording (daily or
weekly timer recording only).
Recording Mode – Select XP , SP , LP , EP ,
SLP or SEP , (See Setting the picture quality/
recording time on page 35). If Manual
Recording is on, then you can also select the
LPCM setting, or MN (press ENTER then use
the / buttons to select the level).
Auto Replace Rec. – Automatically erases
the previous daily or weekly recording when
the next one is recorded.
Genre – Select a record genre (for HDD
recording only).
Bilingual Recording – Select which
channel of a bilingual broadcast to record
(necessary if recording to a Video mode DVD
or to the HDD with the
HDD Recording
Format set to Video Mode On ).
HDD Recording Format – Select Video
Mode On or Video Mode Off depending on
whether you need high-speed copying to
Video mode DVD capability or not.
5 After entering all the timer recording
information, highlight ‘Store Program’
and press ENTER.
The timer recording list screen is displayed
again. The timer program you just input
appears in the list. The rightmost column
shows various timer recording status
messages:
• OK – Can be recorded.
• Time Over – Not enough space on the
HDD (the recording won’t finish).
• Over 12h – Recording time of over 12
hours set (when recording to the HDD
the recording will be split into two titles).
• Overlap – Two timer programs partially
or completely overlap. The one starting
earlier will take priority.
• Until ... (eg., Until 13/8 ) – For a regular
recording, the last program that could
be recorded is shown.
• Data Over –Can’t record because the
disc management area of the disc is full.
• Cancel Once – A regular timer program
is set to skip.
• Can’t Rec – Not possible to record.
• Title Over – Can’t record because there
is already the maximum number of titles
on the disc (HDD: 999; DVD: 99).
• Recording – The program is currently
recording.
• Standby – The recorder is in timer
recording standby.
• nothing displayed – Another timer
recording or copying is in progress.
6 To exit the timer recording screen,
press HOME MENU.
Tip
• To enter a title name for the timer
recording in advance, select Set Title
Name and follow the on-screen display.
Note
• If you set a DVD timer recording but
there is no recordable DVD disc loaded,
or the disc loaded doesn’t have enough
free space for the complete recording,
Recovery is shown. In this case (unless
you load a suitable disc before the
recording actually starts), the recorder
will use the HDD for recording. (The
message
Can’t Rec will appear if there
are already 999 titles on the HDD or if
there is not enough free space on the
HDD for recording.)
DVR640H_WPW_EN.book 42 ページ ２００６年４月１１日 火曜日 午前９時４４分