Pioneer DVR-640H-S - Manual (Page 124)

Additional information 15
124
En
No picture • Check that everything is connected properly (page 14).
• Check that the connected TV and/or the AV amp/receiver is set to
the correct input.
• The recorder may be set to progressive scan with an incompatible
TV. Reset to interlace by pressing and holding the front panel
STOP
button then pressing PLAY .
All settings are reset • If the recorder is unplugged (or there is a power failure) while the
recorder is on, all the settings will be lost.
• Make sure that you switch the recorder into standby before
unplugging the power cord.
Remote control does
not work • If you connected this recorder to another Pioneer product using the
CONTROL IN jack, point the remote control at the other component to
use (page 14).
• Set the remote control to the same ID number as the recorder
(page 119). (When the batteries run down, the remote mode is
automatically reset to
Recorder1 .)
• Use the remote within its operating range (page 6).
• Replace the batteries (page 6).
No sound or sound is
distorted • Make sure that the amp/receiver or TV is set to the correct input and
the volume turned up.
• There is no sound when the picture is paused, or during scanning or
slow motion play. Press
PLAY to resume regular playback.
• DTS discs can only be played if this recorder is connected to a DTS
decoder or DTS compatible amp/receiver. If you have connected a
suitable decoder, also make sure that the
Initial Setup > Audio Out >
DTS Out setting is On .
• Some 96 kHz discs do not output audio through the digital jack. In
this case, switch the input of your amp/receiver to analog.
• Check the audio cable connections (page 14).
• If the sound is distorted, try cleaning the cable plugs.
Cannot switch a bilin-
gual program • During real-time copying it is not possible to switch audio channels.
The main and sub channels are both output.
The picture from the
external input is dis-
torted • If the video signal from the external component is copy-protected,
you cannot connect via this recorder. Connect the component directly
to your TV.
The picture is distorted • Change the Input Line System setting (page 119). (You can also
change it by pressing the
STOP button and OPEN/CLOSE on the
front panel simultaneously with the recorder stopped.)
Problem Remedy
DVR640H_WPW_EN.book 124 ページ ２００６年４月１１日 火曜日 午前９時４４分