Planar PD7130 - Manual (Page 49)

A
ppendix
41
Troubleshooting
Problem Check
Projector does not start
Projector power cord is not plugged into the wall outlet.
Remote control batteries have run out.
No picture
The selected input mode is wrong.
Cables may be incorrectly connected to the rear panel of the projector.
Power to the external connected device is off.
The video signal format of the video equipment is not set correctly.
Color is faded
Picture adjustments are incorrectly set.
Picture is blurred
Focus is incorrectly set.
The projection distance exceeds the focus range.
Picture contains noise
(PC input only)
Try "Auto tune".
Adjust the "Clock" setting.
Adjust the "Phase” setting.
Picture is green on
INPUT1 or 2 COMPONENT
Change the input signal type of the video equipment.
Picture is dark or
bright and whitish
Picture adjustments are incorrectly set.
Picture is too bright
and whitish
Picture adjustments are incorrectly set.