Panasonic WV-CW474S - Manual (Page 13)

(1) Loosen the pan lock screw (stain-
less) with the Phillips screwdriver.
Panning becomes adjustable.
(2) Loosen the tilting lock screw
(stainless) with the Phillips screw-
driver.
Tilting becomes adjustable.
Note: Do not touch a black screw
placed on the opposite side.
(3) After adjusting panning and tilting,
tighten both of the lock screws
with the Phillips screwdriver.
(4) Adjust the azimuth.
If the image is slanting, turn the azimuth adjuster to obtain a leveled image.
6. Adjust the focus.
Precautions:
• The focus adjustment should be done at the same time as the camera angle adjust-
ment.
• Set the zoom position to TELE before focusing.
(1) Loosen the focus lock screw by turning it counterclockwise.
The focus lock screw and the tip of the focus lever are identical with each other. The
focus lever becomes movable after loosening the focus lock screw.
(2) Adjust the focus by moving the focus lever to NEAR side or FAR side.
(3) Turn the focus lock screw clockwise to tighten the focus lever after adjustment.
7. Adjust the zoom.
(1) Loosen the zoom lock screw by turning it counterclockwise.
The zoom lock screw and the tip of the zoom lever are identical with each other.
The zoom lever becomes movable after loosening the zoom lock screw.
(2) Adjust the zoom by moving the zoom lever to TELE side or WIDE side.
(3) Turn the zoom lock screw clockwise to tighten the zoom lever after adjustment.
8. Reinstall the dome cover to the
main body by tightening three
dome cover mounting screws.
Azimuth adjuster
TELE
Zoom lock screw
Focus lock screw
FAR
NEAR
WIDE
Tighten the dome
cover mounting
screw x3
5. Adjust the panning, tilting and azimuth while watching the monitor.
Notes:
• You can check images by connecting an LCD monitor and such devices to the
monitor output jack.
However, images are not avail-
able on the monitor connected
to the video output cable.
• When connecting the LCD
monitor's plug to the monitor
output jack, the mode is auto-
matically set to ELC.
When disconnecting it, ELC
mode is automatically can-
celed.
• The signal from the monitor out-
put jack can cause smear on
the monitor when a high-lumi-
nance area is displayed.
Pan lock screw
(stainless)
Tilting lock screw (stainless)
Panning table
Variable angles
plus or minus 75
°
(max.)