Setup (initial settings) – Panasonic DVCPRO AJ-D250P User Manual
Page 24
24
Setup (Initial Settings)
SET–UP MENU
NO
FACTORY (ALL)
FACTORY (NOT SYSTEM)
USER (ALL)
USER (NOT SYSTEM)
Press the MENU-UP button or MENU-DOWN
button to move the cursor to FACTORY (ALL),
and press the SET button.
O
If the cursor is moved to FACTORY (NOT
SYSTEM) and this operation is performed, all
the menus except the SYSTEM menu will be
restored to the factory settings.
O
If the cursor is moved to NO and this operation
is performed, operation will return to the menu
screen without restoring the factory settings.
4
Press the MENU-UP button or MENU-DOWN
button to move the cursor to USER (ALL), and
press the SET button.
O
If the cursor is moved to USER (NOT
SYSTEM) and this operation is performed, all
the menus except the SYSTEM menu will be
updated.
O
If the cursor is moved to NO and this operation
is performed, operation will return to the menu
screen without updating the settings.
5
Set the LOCAL/MENU/REMOTE switch to the
LOCAL or REMOTE position.
The menu setting procedure is now terminated.
5
Set the LOCAL/MENU/REMOTE switch to the
LOCAL or REMOTE position.
The menu setting procedure is now terminated.
7
SET–UP MENU
NO
USER (ALL)
USER (NOT SYSTEM)
Press the MENU-UP button or MENU-DOWN
button to position the cursor at SAVE, and
press the SET button.
The unit is set to the SAVE mode, and the SAVE
screen appears on the video monitor.
4
SAVE OK?
NO
YES
The screen to confirm whether SAVE is to be
initiated or canceled now appears. Press the
MENU-UP button or MENU-DOWN button to
move the cursor to the YES position, and
press the SET button.
The settings are now saved in the memory.
6
How to set the user default
settings
Set the LOCAL/MENU/REMOTE switch to the
MENU position.
The unit is now set to the menu setting mode,
and the menu screen appears on the video
monitor.
1
Performs steps
2
through
6
of “How to
perform the settings using the on-screen
menus,” and change to the desired settings.
(See page 23)
2
Press the RESET button.
The unit is set to the default setting mode, and
the default setting screen appears on the video
monitor.
3
SELECT
MODE
ESCAPE
LOAD
SAVE
PROTECT
Press the MENU-UP button or MENU-DOWN
button to position the cursor at LOAD, and
press the SET button.
The unit is set to the LOAD mode, and the LOAD
screen appears on the video monitor.
3