Philips SWW1810 - Manual (Page 18)

18
9 Frequently asked question
The power LED on the
receiver is not lit up in red in
standby mode.
• Make sure that there is power supply for the transmitter and
receiver.
The computer screen image is
not full screen on my TV.
1
Right-click on an open space on your desktop.
2
Select Graphics Options > Output to > Digital Television (Now
the laptop image will only appear on your TV).
3
Once again, right-click on an open space on your desktop.
4
Select Screen Resolution.
5
On the pop-up box increase the resolution settings till the laptop
image better fits your TV screen.
6
Select OK and KEEP CHANGES when you are satisfied with
your image size..
There is no video displayed on
my TV screen.
• Make sure that the appropriate cables are selected and inserted
to the transmitter, receiver, and HDTV.
• Make sure that you select HDMI as the input source on your
HDTV.
• Check the power LED and SOURCE LED on the receiver:
• Flashing blue power LED: Make sure that the transmission
range between receiver and transmitter is not over 65 feet
(19.7 meters) transmission distance. Move the transmitter
closer to the receiver.
• Solid blue power LED + slow and flashing source LED:1)
Make sure that the frame rate and video resolution of your
source device equipment are supported and conformed to
the technical specification. 2) Connect the source device to
your TV with an HDMI cable to check the compatibility of
the video format. 3) Make sure that the video solution your
source device is supported (See the chapter ‘Technical data’).
• Solid blue power LED + quick and flashing source LED: 1)
Make sure that the proper cables are connected among the
transmitter, receiver and HDTV. 2) Make sure that the source
devices connected to the transmitter are powered on.
EN