Philips SE171 - Manual (Page 11)

11
Français
EN
3 Get started
Caution
Ensure you have read the safety instructions in •
the “Important” section before you connect
and install your handset.
Connect the base station
Warning
Risk of product damage! Ensure that the •
power supply voltage corresponds to the
voltage printed on the back or the underside
of the phone.
Use only the supplied power adapter to charge •
the batteries.
Note
If you subscribe to the digital subscriber line •
(DSL) high speed internet service through
your telephone line, ensure you install a DSL
filter between the telephone line cord and
the power socket.. The filter prevents noise
and caller ID problems caused by the DSL
interference. For more information on the DSL
filters, contact your DSL service provider.
The type plate is located on the bottom of the •
base station.
1
Connect each end of the power adapter
to:
the DC input jack at the bottom of •
the base station;
the power socket on the wall. •
2
Connect each end of the power adapter
to (for multi handset packs):
the DC input jack at the bottom of •
the extra handset charger.
the power socket on the wall. •
3
Connect each end of the line cord to:
the telephone socket at the bottom •
of the base station;
the telephone socket on the wall. •